Procedure 5
Inspecting SRS Intermittent Problem By Using CONSULT - Diagnosis Mode1. Turn ignition switch OFF.
Diagnostic Procedure 5:
2. Connect CONSULT to Data link connector.
3. Turn ignition switch ON.
Diagnostic Procedure 5:
4. Touch "START".
Diagnostic Procedure 5:
5. Touch "AIRBAG".
Diagnostic Procedure 5:
6. Touch "SELF-DIAG [PAST]".
Diagnostic Procedure 5:
7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.
Diagnostic Procedure 5:
If no self-diagnostic failure is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".
Diagnostic Procedure 5:
8. Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.
Diagnostic Procedure 5:
9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to the INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART.
12. Touch "BACK" key of CONSULT until "SELECT SYSTEM" appears, then turn off CONSULT
13. Turn ignition switch OFF, then disconnect CONSULT and both battery cables.
14. Repair the system as outlined by the Repair order that corresponds to the problem code in INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART.
15. Go to DIAGNOSTIC PROCEDURE 3 Procedure 3.
Intermittent Problem Diagnostic Code Chart (self-diag [past] Of Trouble Diag Record):
INTERMITTENT PROBLEM DIAGNOSTIC CODE CHART (SELF-DIAG [PAST] of TROUBLE DIAG RECORD)