Rear

RUBBING SURFACE
- Check rotor for roughness, cracks or chips.

RUNOUT
1. Secure rotor to wheel hub with two nuts (M12 x 1.25).





2. Check runout using a dial indicator.

NOTE: Make sure that wheel bearing axial end play is within the specifications before measuring.

3. Change relative positions of rotor and wheel hub so that runout is minimized.
Maximum runout: 0.07 mm (0.0028 inch)

THICKNESS
- Rotor repair limit:
Minimum thickness: 8.0 mm (0.315 inch)





Thickness variation (at least 8 positions): Maximum 0.02 mm (0.0008 inch)

NOTE: Replace rotor if any of the above do not meet the specifications.