Restraints and Safety Systems: Service Precautions

^ Do not use electrical test equipment on any circuit related to the SRS unless instructed. SRS wiring harnesses are covered with yellow insulation just before the harness connectors for easy identification.
^ Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
For approximately 3 minutes after the cables are removed, it is still possible for the air bag to deploy. Therefore, do not work on any air bag system connectors or wires until at least 3 minutes have passed.
^ Diagnosis sensor unit must always be installed with arrow mark "<-" pointing towards the front of the vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities and rust before installation and replace as required.
^ The rotation of the spiral cable is limited. The spiral cable must be aligned in the neutral position. If the steering gear must be removed, set the front wheels in the straight-ahead direction. Do not rotate the steering column while the steering gear is removed to avoid damaging the spiral cable.
^ Handle air bag modules carefully. Always place them with the pad side facing upward.
^ Do not use old bolts after removing any SRS parts; replace with new bolts. Conduct self-diagnosis to check entire SRS for proper operation.
^ After air bag inflates, the front instrument panel assembly should be replaced if damaged.