Ignition Ballast Resistor: Testing and Inspection
COMPONENT INSPECTIONResistor
1. Disconnect resistor harness connector.
2. Check resistance between terminals (1) and (2).
Resistance: Approximately 2.2 K Ohms at 25°C (77°F)
If NG, replace resistor.
Resistor
1. Disconnect resistor harness connector.
2. Check resistance between terminals (1) and (2).
Resistance: Approximately 2.2 K Ohms at 25°C (77°F)
If NG, replace resistor.