A/T COMM LINE
COMPONENT DESCRIPTIONThe malfunction information related to A/T (Automatic Transaxle) is transferred through the line (circuit) from TCM (Transmission Control Module) to ECM. Therefore, be sure to erase the malfunction information such as DTC not only in TCM (Transmission Control Module) but also ECM after the A/T related repair.
ECM TERMINALS AND REFERENCE VALUE
Specification data are reference values, and are measured between each terminal and (25) (ECCS ground).
ON BOARD DIAGNOSIS LOGIC
DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE
NOTE: Before performing following procedure, confirm that battery voltage is more than 10.5V.
With CONSULT
1) Turn ignition switch "ON".
2) Select "DATA MONITOR" mode with CONSULT.
3) Wait at least 40 seconds or start engine and wait at least 40 seconds.
Electrical Diagrams
Circuit Connectors
DIAGNOSTIC PROCEDURE