Operation CHARM: Car repair manuals for everyone.

With Generic Scan Tool





SYSTEM DESCRIPTION
The ECM performs ON/OFF control of the front heated oxygen sensor heaters corresponding to the engine speed.






CONSULT REFERENCE VALUE IN DATA MONITOR MODE
Specification data are reference values.






ECM TERMINALS AND REFERENCE VALUE
Specification data are reference values, and are measured between each terminal and (25) (ECCS ground).






ON BOARD DIAGNOSIS LOGIC






OPERATION



DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 10.5V and 16V.


With Generic Scan Tool
(1) Start engine and run it for at least 6 seconds at idle speed.
(2) Select "MODE 3" with GST.







Electrical Diagrams/Left Bank






Circuit Connectors/Left Bank






Electrical Diagrams/Right Bank






Circuit Connectors/Right Bank






DIAGNOSTIC PROCEDURE


COMPONENT INSPECTION
Front heated oxygen sensor heater






Check resistance between terminals (3) and (1).

Resistance: 2.3 - 4.3 Ohms at 25°C (77°F)

Check continuity between terminals (2) and (1).(3) and (2).

Continuity should not exist.

If NG, replace the front heated oxygen sensor.

CAUTION: Discard any heated oxygen sensor which has been dropped from a height of more than 0.5 m (19.7 in) onto a hard surface such as a concrete floor; use a new one.