With CONSULT - Screen Terms

COMPONENT DESCRIPTION
The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent.
This solenoid (the EVAP canister vent control valve) responds to signals from the ECM.
When the ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal the canister vent. The ability to seal the vent is a necessary part of the diagnosis algorithms for other evaporative loss system components.
This solenoid valve is used only for diagnosis, and usually remains opened.
When the vent is closed, under normal purge conditions, the evaporative loss system is depressurized allowing "EVAP Control System (Small Leak)" diagnosis.






CONSULT REFERENCE VALUE IN DATA MONITOR MODE
Specification data are reference values.






ECM TERMINALS AND REFERENCE VALUE
Specification data are reference values, and are measured between each terminal and (25) (ECCS ground).






ON BOARD DIAGNOSIS LOGIC


DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

TESTING CONDITION:
Before performing the following procedure, confirm battery voltage is more than 11V.






With CONSULT
(1) Turn ignition switch "ON".
(2) Select "DATA MONITOR" mode with CONSULT.
(3) Start engine and wait at least 5 seconds.






Electrical Diagrams






Circuit Connectors






DIAGNOSTIC PROCEDURE



COMPONENT INSPECTION


EVAP canister vent control valve
Check air passage continuity.









With CONSULT
(1) Remove EVAP vent control valve from EVAP canister with its harness connector connected.
(2) Disconnect fresh air vent hose from EVAP vent control valve.
(3) Turn ignition switch "ON".
(4) Perform "VENT CONTROL/V" in "ACTIVE TEST" mode with CONSULT.
If NG, check valve below.