Control Module: Service Precautions

TCM Service Precautions







Before connecting or disconnecting the TCM harness connector, turn ignition switch OFF and disconnect negative battery terminal. Failure to do so may damage the TCM. Because battery voltage is applied to TCM even if ignition switch is turned off.






When connecting TCM harness connector, tighten securing bolt until the orange indicator appears.
3.0 - 5.0 N.m (0.3 - 0.5 kg-m, 26 - 43 in-lb)








When connecting or disconnecting pin connectors into or from TCM, take care not to damage pin terminals (bend or break).
Make sure that there are not any bends or breaks on TCM pin terminal, when connecting pin connectors.







Before replacing TCM, perform TCM input/output signal inspection and make sure whether TCM functions properly or not.







After performing each TROUBLE DIAGNOSIS, perform "DTC (Diagnostic Trouble Code) CONFIRMATION PROCEDURE".
The DTC should not be displayed in the "DTC CONFIRMATION PROCEDURE" if the repair is completed.