Operation CHARM: Car repair manuals for everyone.

Air Bag Systems: Service and Repair

Air Bag Warning Lamp:




CAUTION: Do not use a circuit tester to check SRS circuit.

1. Check operation of "AIR BAG" warning lamp.
After turning ignition key to "ON" position, "AIR BAG" warning lamp illuminates. The "AIR BAG" warning lamp will go off after about 7 seconds if no malfunction is detected.
If any of the following warning lamp conditions occur, immediately check the air bag system.
- The "AIR BAG" warning lamp does not illuminate when the ignition switch is turned "ON".
- The "AIR BAG" warning lamp does not go off about 7 seconds after the ignition switch is turned "ON".
- The "AIR BAG" warning lamp blinks after about 7 seconds after the ignition switch is turned "ON".

2. Visually check SRS components.
1. Diagnosis sensor unit
- Check diagnosis sensor unit and bracket for dents, cracks or deformities.
- Check connectors for damage and terminals for deformities.

2. Air bag module and steering wheel
- Remove air bag module from steering wheel, instrument panel or seatback. Check harness cover and connectors for damage, terminals for deformities, and harness for binding.
- Install driver air bag module to steering wheel to check tit or alignment with the wheel.
- Check steering wheel for excessive free play.
- Install passenger air bag module to instrument panel to check fit or alignment with the instrument panel.
- Install side air bag module to seatback to check fit and alignment with the seat.

3. Spiral cable
- Check spiral cable for dents, cracks, or deformities.
- Check connectors and protective tape for damage.
- Check steering wheel for noise, binding or heavy operation.

4. Main harness, air bag harness, body harness
- Check connectors for poor connections, damage, and terminals for deformities.
- Check harnesses for binding, chafing or cuts.

5. Satellite sensor
- Check satellite sensor (including bracket portion) for dents, cracks or deformities.
- Check connectors for damage, and terminals for deformities.

CAUTION: Replace previously used special bolts and ground bolt with new ones.