Procedure 4

Final Checking After Repairing SRS By Using CONSULT - Diagnosis Mode

Data Link Connector:

1. After repairing SRS, connect both battery cables.
2. Connect CONSULT to Data link connector.
3. Turn ignition switch from "OFF" to "ON".

Diagnostic Procedure 4 (With Consult):

4. Touch "START".

Diagnostic Procedure 4 (With Consult):

5. Touch "AIRBAG".

Diagnostic Procedure 4 (With Consult):

6. Touch "SELF-DIAG [CURRENT]".

Diagnostic Procedure 4 (With Consult):

7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed.
If any problem code is displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2. Procedure 2

Diagnostic Procedure 4 (With Consult):

8. Touch "ERASE".

NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

If the memory of the malfunction "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even it the malfunction is repaired completely.

Diagnostic Procedure 4 (With Consult):

9. Touch "BACK" key of CONSULT to select "SELF-DIAG [PAST]" in the "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".

Diagnostic Procedure 4 (With Consult):

10. Check that no self-diagnostic failure is detected on "SELF-DIAG [PAST]".
11. Touch "BACK" key of CONSULT until SELECT SYSTEM appears in order to return to User mode from Diagnosis mode, turn off CONSULT, then disconnect CONSULT
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1 to check SRS operation by using "AIR BAG" warning lamp with User mode. Procedure 1