Relationship Chart - Driving Pattern For "Misfire"
Note: Check TSBs for any available updates to drive patterns.
RELATIONSHIP BETWEEN MIL, DTC, 1ST TRIP DTC AND DRIVING PATTERNS FOR "MISFIRE"
EXPLANATION FOR DRIVING PATTERNS FOR "MISFIRE
Driving pattern B means the vehicle operation as follows:
All components and systems should be monitored at least once by the OBD system.
The B counter will cleared when the multifunction is detected once regardless of the driving pattern.
The B counter will be counted up when driving pattern B is satisfied without any malfunction.
The MIL will go off when the B counter reaches 3. (*2 in "OBD SYSTEM OPERATION CHART")
Driving pattern C means the vehicle operation as follows:
The following conditions should be satisfied at the same time:
Engine speed: (Engine speed in the freeze frame data) ±375 rpm
Calculated load value: (Calculated load value in the freeze frame data) x (1 ± 0.1) [%] Engine coolant temperature (T) condition:
When the freeze frame data shows lower than 70°C (158°F), "T" should be lower than 70°C (158°F).
When the freeze frame data shows higher than or equal to 70°C (158°F), "T" should be higher than or equal to 70°C (158°F).
Example:
If the stored freeze frame data is as follows:
Engine speed: 850 rpm, Calculated load value: 30%, Engine coolant temperature: 80°C (176°F) To be satisfied with driving pattern C, the vehicle should run under the following conditions:
Engine speed: 475 - 1,225 rpm, Calculated load value: 27 - 33%, Engine coolant temperature: more than >= 70°C (158°F)
The C counter will be cleared when the malfunction is detected regardless of (1).
The C counter will be counted up when (1) is satisfied without the same malfunction.
The DTC will not be displayed after C counter reaches 80.
The 1st trip DTC will be cleared when C counter is counted a time without the same malfunction after DTC is stored in ECM.