Installation

INSTALLATION

Aligning Turn Signal Cancel Tab:

1. Set the front wheels in the straight-ahead position.
2. Align the turn signal cancel tab with the notch of combination switch as shown.

Driver Air Bag Module And Spiral Cable - Installation:

3. Rotate the spiral cable fully clockwise until tight.
4. Rotate the spiral cable counterclockwise approximately 2.5 turns and align white pin with arrow on housing.

CAUTION: The spiral cable may snap during steering operation if the cable is installed improperly. Also, with the steering linkage disconnected, the cable may snap by turning the steering wheel more than 2.5 turns to the left or right of the neutral position.

5. Connect spiral cable and driver air bag harness connectors and tighten screws. Install steering column covers and driver side instrument lower panel.

Air Bag Module And Spiral Cable - Installation:

6. Install steering wheel, setting spiral cable pin guide, and pull spiral cable through.
7. Connect horn connector and engage horn connector with pawls in steering wheel. Move driver air bag module connector away from steering wheel lower lid opening.
8. Tighten nut.

Steering Wheel Nut: 29 - 39 N.m (3.0 - 4.0 kg-m, 22 - 29 ft-lb)

9. Position driver air bag module and tighten with new special bolts.
10. Connect driver air bag module connector
11. Install Automatic Speed Control Device (ASCD) switch and tighten screws.
12. Install all lids.

Driver Air Bag Module And Spiral Cable - Installation:

13. Connect both battery cables.
14. Conduct Self-diagnosis to ensure entire SRS operates properly. (Use CONSULT or warning lamp check). Clearing Trouble Codes
15. Turn steering wheel to the left end and then to the right end fully to make sure that spiral cable is set in the neutral position. If "AIR BAG" warning lamp blinks or stays on (at the User mode), it shows the spiral cable may be snapped due to its improper position. Perform self-diagnosis again (Use CONSULT or warning lamp check). Clearing Trouble CodesIf a malfunction is detected, replace the spiral cable with a new one.