Overhaul

DISASSEMBLY AND ASSEMBLY
Refer to the illustrations when servicing, noting the following:
- When disassembling and assembling, unlock steering lock with key.
- Remove combination switch.
- Ensure that rounded surface of snap ring faces toward bearing when snap ring is installed.





- Install snap ring on upper shaft with a suitable tool.








- When servicing the steering lock, break the self-shear type screws with a drill or other appropriate tool. When installing use self-shear type screws, then tighten until heads break off.





- After installing steering column, check tilt mechanism operation.

INSPECTION
When steering wheel does not turn smoothly, check the steering column as follows and replace damaged parts.
1. Check column bearings for damage or unevenness. Lubricate with recommended multi-purpose grease or replace steering column as an assembly, if necessary.
2. Check jacket tube for deformation or breakage.





3. When the vehicle is involved in a light collision, check column length "L". If it is not within specifications, replace steering column as an assembly. Column length "L": 535.9 - 538.1 mm (21.10 - 21.18 inch).