Cylinder Block Assembly: Specifications
| Distortion | Standard | Less Than 0.03 Millimeter (mm) | ||
| Limit | 0.10 Millimeter (mm) | |||
| Cylinder Bore | Inner Diameter | Grade 1 | Standard | 89.000 - 89.010 Millimeter (mm) |
| Limit | 0.2 Millimeter (mm) | |||
| Grade 2 | Standard | 89.010 - 89.020 Millimeter (mm) | ||
| Limit | 0.2 Millimeter (mm) | |||
| Grade 3 | Standard | 89.020 - 89.030 Millimeter (mm) | ||
| Out-Of-Round (X - Y) | Standard | Less Than 0.015 Millimeter (mm) | ||
| Taper (A - B) | Standard | Less Than 0.010 Millimeter (mm) | ||
| Difference In Inner Diameter Between Cylinders | Standard | Less Then 0.03 Millimeter (mm) | ||
| Limit | 0.2 Millimeter (mm) | |||
| Nominal Cylinder Block Height: H From crankshaft center | Standard | 246.95 - 247.05 Millimeter (mm) | ||
| Limit | 0.2 Millimeter (mm) Total amount of cylinder head resurfacing plus cylinder block resurfacing |