Procedure 3

Final checking after repairing SRS by using CONSULT - Diagnosis mode






1. Check that both battery cables are connected.
2. Connect CONSULT to Data link connector.
3. Turn ignition switch from OFF to ON.






4. Touch "START".






5. Touch "AIRBAG".






6. Touch "SELF-DIAG [CURRENT]".





7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed.
If any malfunction was detected on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 and repair malfunctioning part completely. Procedure 2






8. Touch "ERASE".

NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.






9. Touch "BACK" key of CONSULT to "SELECT DIAG MODE" screen.
Touch "SELF-DIAG [PAST]".






10. Check that no malfunction is detected on "SELF-DIAG [PAST]".
11. Touch "BACK" key of CONSULT until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode, turn oft CONSULT then disconnect CONSULT.
12. Turn ignition switch OFF.
13. Go to DIAGNOSTIC PROCEDURE 1 to check SRS operation by using "AIR BAG" warning lamp with User mode.

Procedure 1