Procedure 5

Inspecting SRS intermittent malfunction by using CONSULT - Diagnosis mode







1. Turn ignition switch OFF.

2. Connect CONSULT to Data link connector.







3. Turn ignition switch ON.

4. Touch "START".







5. Touch "AIRBAG".







6. Touch "SELF-DIAG [PAST]".







7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.






If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".







8. Touch "TROUBLE DIAG RECORD"

NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.







9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".

10. Touch "PRINT".







11. Compare diagnostic codes to the INTERMITTENT MALFUNCTION DIAGNOSTIC CODE CHART.

12. Touch "BACK" key of CONSULT until "SELECT SYSTEM" appears, then turn off CONSULT.

13. Turn ignition switch OFF, then disconnect CONSULT and both battery cables.

14. Repair the system as outlined by the Repair order that corresponds to the self-diagnostic result in INTERMITTENT MALFUNCTION DIAGNOSTIC CODE CHART.For replacement procedure of component parts.

15. Go to DIAGNOSTIC PROCEDURE 3.