Keyless Entry: Testing and Inspection

Trouble Symptom



^ All instances of remote control system do not operate.



^ Some functions of multi remote controller do not operate

Note:
^ The unlock and panic alarm operation of the multi-remote control system does not activate with the ignition key inserted in the ignition key cylinder.
^ The lock operation of the multi-remote control system does not activate with the key inserted in the ignition key cylinder and one or more of the front doors are open.




Diagnostic Procedure 1
Check remote controller battery
NOTE: Remote controller does not function if battery is not set correctly.







Diagnostic Procedure 2
All remote controls do not function even if remote controller is operated properly




Diagnostic Procedure 3
Room lamp does not turn on 30 seconds when pressing unlock button of remote controller. Everything else functions.




Diagnostic Procedure 4
Hazard indicator does not flash twice when pressing lock button of remote controller. Everything else functions.

ELECTRICAL COMPONENTS INSPECTION





Door Switches
Check continuity between terminals when door switch is pushed and released.






Door Lock Actuator (Door Unlock Sensor)
Check continuity between terminals when door is locked and unlocked.





Key Switch (Insert)
Check continuity between terminals when key is inserted in ignition key cylinder and key is removed from ignition key cylinder.






ID Code Entry Procedure

NOTE:
^ If you need to activate more than two additional new remote controllers, repeat the procedure "Additional ID code entry" for each new remote controller.
^ If the same ID code that exists in the memory is input, the entry will be ignored.
^ Entry of four ID codes maximum is allowed and any attempt to enter more will be ignored.
^ Any ID codes entered after termination of the "setting mode" will not be accepted. Additional remote control signals will be inhibited if not entered during the "setting" mode.