Removal and Installation

REMOVAL

CAUTION:
- The rotation of the spiral cable (SRS "AIR BAG" component part) is limited. If the steering gear must be removed, set the front wheels in the straight-ahead direction. Do not rotate the steering column while the steering gear is removed.
- Remove the steering wheel before removing the steering lower joint to avid damaging the SRS spiral cable.





1. Remove steering wheel. Refer to Image.
2. Disconnect electrical connectors from the ignition switch and combination switch.
3. Remove three screws securing combination switch and remove combination switch.
4. Remove key interlock cable (A/T models).
5. Remove bolt from lower joint.
6. Remove four nuts securing steering column and remove steering column.

INSTALLATION





- When installing steering column, finger tighten all lower bracket and clamp retaining nuts; then tighten them securely. Do not apply undue stress to steering column.
- When attaching lower coupling joint, be sure tightening bolt faces cutout portion.

CAUTION: After installation, turn steering wheel to make sure it moves smoothly. Ensure the number of turns from the straight forward position to left and right locks are the same. Be sure that the steering wheel is in a neutral position when driving straight ahead.