Cylinder Block Assembly: Specifications
| Surface Flatness | Standard | Less Than 0.03 | ||
| Limit | 0.10 | |||
| Cylinder Bore | Inner Diameter | Standard | Grade No. 1 | 93.000 - 93.010 |
| Grade No. 2 | 93.011 - 93.020 | |||
| Grade No. 3 | 93.021 - 93.030 | |||
| Wear Limit | 0.20 | |||
| Out-Of-Round (X - Y) | Less Than 0.015 | |||
| Taper (A - B) | Less Than 0.015 | |||
| Main Journal Inner Diameter | Grade No. A | 63.993 - 93.994 | ||
| Grade No. B | 64.994 - 63.995 | |||
| Grade No. C | 63.995 - 63.996 | |||
| Grade No. D | 63.996 - 63.997 | |||
| Grade No. E | 63.997 - 63.998 | |||
| Grade No. F | 63.998 - 63.999 | |||
| Grade No. G | 63.999 - 64.000 | |||
| Grade No. H | 64.000 - 64.001 | |||
| Grade No. J | 64.001 - 64.002 | |||
| Grade No. K | 64.002 - 64.003 | |||
| Grade No. L | 64.003 - 64.004 | |||
| Grade No. M | 64.004 - 64.005 | |||
| Grade No. N | 64.005 - 64.006 | |||
| Grade No. P | 64.006 - 64.007 | |||
| Grade No. R | 64.007 - 64.008 | |||
| Grade No. S | 64.008 - 64.009 | |||
| Grade No. T | 64.009 - 64.010 | |||
| Grade No. U | 64.010 - 64.011 | |||
| Grade No. V | 64.011 - 64.012 | |||
| Grade No. W | 64.012 - 64.013 | |||
| Grade No. X | 64.013 - 64.014 | |||
| Grade No. Y | 64.014 - 64.015 | |||
| Grade No. 4 | 64.015 - 64.016 | |||
| Grade No. 7 | 64.016 - 64.017 | |||
| Difference In Inner Diameter Between Cylinders | Standard | Less Than 0.03 |