Trouble Diagnosis

CONSULT

Consult Inspection Procedures




1. Turn Ignition switch "OFF" .
2. Connect "CONSULT" to the data link connector.




3. Turn Ignition switch "ON" .
4. Touch "START".




5. Touch "IVMS"




6. Touch "MULTI-REMOTE CONT SYS"




^ DATA MONITOR, and ACTIVE TEST are available for the multi-remote control system


Trouble Diagnosis




Work Flow

NOTE:
^ When Local Control Unit (LCU) connectors are disconnected for more than 1 minute such as during trouble diagnoses, the "disconnected" data will be memorized by the Body Control Module (BCM). Therefore, after reconnecting the LCU connectors, erase the memory
^ To erase the memory, perform the procedure below. Erase the memory with CONSULT or turn the ignition switch to "OFF" position and remove 7.5 A fuse (No. (56), located in the fuse and fusible link box).

Trouble Symptom




^ All functions of remote control system do not operate.




^ Some functions of the multi-remote controller do not operate.

NOTE:
^ The unlock and trunk open operation of multi-remote control system does not activate with the ignition key inserted in the ignition key cylinder.
^ The lock operation of multi-remote control system does not activate with the key inserted in the ignition key cylinder or it one of the doors is opened




Diagnostic Procedure 1

NOTE: Remote controller does not function if battery is not set correctly.




Diagnostic Procedure 2







Diagnostic Procedure 3




Diagnostic Procedure 4




Diagnostic Procedure 5




Diagnostic Procedure 6


ID Code Entry Procedure

Enter the identity (ID) code manually when:
^ remote controller or control unit (LCU05) is replaced.
^ an additional remote controller is activated.