Manual

MODE DOOR
1. Install mode door motor on heater unit and connect it to main harness.
Make sure lever of mode door motor is fitted into the slit of mode door link.
2. Turn ignition switch to ON.
3. Turn VENT switch ON.
4. Turn DEF switch ON. Check that side link operates at the fully-open position. Also turn DEF switch ON to check that side link operates at the fully-open position.




INTAKE DOOR
1. Install intake door motor on intake unit and connect it to main harness.
Make sure lever of intake door motor is fitted into the slit of intake door link.
2. Turn ignition switch to ON.
3. Turn REC switch ON.
4. Check that intake door operates properly when REC switch is turned ON and OFF.