Procedure 2

Inspecting SRS malfunctioning parts by using CONSULT - Diagnosis mode






1. Turn ignition switch "OFF".
2. Connect "CONSULT" to Data link connector.






3. Turn ignition switch "ON".
4. Touch "START".






5. Touch "AIRBAG".






6. Touch "SELF-DIAG [CURRENT]".






7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".






If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in DIAGNOSTIC PROCEDURE 1, check the battery voltage. Procedure 1If the battery voltage is less than 9 V, charge the battery. Then go to DIAGNOSTIC PROCEDURE 4 for final checking.Procedure 4 If the battery voltage is OK, go to DIAGNOSTIC PROCEDURE 6, to diagnose the following situations: Procedure 6

- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.

8. Touch "PRINT".
9. Compare diagnostic codes to "CONSULT DIAGNOSTIC CODE CHART". Trouble Code Description and Repairs
10. Touch "BACK" key of CONSULT until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode, then turn off CONSULT.
11. Turn ignition switch "OFF", then disconnect CONSULT and both battery cables.

CONSULT DIAGNOSTIC CODE CHART ("SELF-DIAG [CURRENT]") {1 Of 2}:

CONSULT DIAGNOSTIC CODE CHART ("SELF-DIAG [CURRENT]") {2 Of 2}:

12. Repair the system as outlined by the "Repair order" in CONSULT DIAGNOSTIC CODE CHART, that corresponds to the self-diagnostic result. Trouble Code Description and RepairsFor replacement procedure of component parts, refer to removal and installation.
13. After repairing the system, go to DIAGNOSTIC PROCEDURE 4 for final checking. Procedure 4
CONSULT can only show one seat belt pre-tensioner malfunction as self-diagnosis result at a time. Check self-diagnosis result with CONSULT whether other malfunctions are detected after repairing one seat belt pre-tensioner malfunction.