Transmission Position Sensor/Switch: Adjustments

Park/Neutral Position (PNP) Switch Adjustment





1. Remove control cable end from manual shaft.
2. Set manual shaft in "N" position.
3. Loosen park/neutral position (PNP) switch fixing bolts.





4. Use a 4 mm (0.157 inch) pin for this adjustment.
a. Insert the pin straight into the manual shaft adjustment hole.
b. Rotate park/neutral position (PNP) switch until the pin can also be inserted straight into hole in park/neutral position (PNP) switch.
5. Tighten park/neutral position (PNP) switch fixing bolts.
6. Remove pin from adjustment hole after adjusting park/neutral position (PNP) switch.
7. Reinstall any part removed.
8. Adjust control cable.
9. Check continuity of park/neutral position (PNP) switch.