Water Pump

Removal





1. Drain coolant from radiator and cylinder block.
2. Loosen water pump pulley bolts.
3. Remove drive belts.
4. Remove front RH wheel, engine side cover and front cover.
5. Remove three lower water pump bolts.





6. Position jack to support engine and remove front engine mount.
7. Remove remaining water pump bolt to remove water pump.

CAUTION:
- When removing water pump assembly, be careful not to get coolant on drive belt.
- Water pump cannot be disassembled and should be replaced as a unit.
- After installing water pump, connect hose and clamp securely, then check for leaks using radiator cap tester.
- Use Genuine RTV silicone sealant Part No. 999 MP-A7007 or equivalent.

Inspection





- Check body assembly for rust or corrosion.
- Check for rough operation due to excessive end play.

Installation





1. Use a scraper to remove liquid gasket from water pump.
- Also remove traces of liquid gasket from mating surface of cylinder block.





2. Apply a continuous bead of liquid gasket to mating surface of water pump.
- Use Genuine RTV silicone sealant Part No. 999 MP-A7007 or equivalent.