Service Procedure

Programming additional remote controls

When programming additional remote controls, it is possible to erase a previously-programmed remote control. When an additional remote control is added, it may be necessary to program all remote controls at this time.

1. Sit inside the vehicle with the hood, trunk and all doors closed.

2. Place the console switch in the ALARM OFF position.

3. Turn the ignition key from the OFF position to the ON position SIX times within 10 seconds.

NOTE:
OFF to ON to OFF = 1 time.

4. Move the console switch from the ALARM OFF position to the AUTO position and then to the ALARM OFF position.

5. Press the Lock / Unlock button on the remote control ONE time.

6. To program additional remote controls, repeat steps 4 & 5.

7. To conclude programming at any time, open any door.











System Operational Check

Before beginning "System Operational Check", turn the ignition key on, roll down the drivers side window, turn the ignition off and remove the key. Close all doors, trunk and hood.





Diagnostic Procedure # 1

SYMPTOM:
No response from remote control

NOTE!
The remote controls that are supplied with the system are pre-programmed to the control unit. If the control unit or a remote control is replaced, the remote controls will need to be programmed to the control unit. The control unit can be programmed to receive up to four remote controls. However, when a remote control is programmed it may be necessary to program all remote controls that are to be used with the system. Refer to "SYSTEM DESCRIPTION" for programming instructions.

APPLICABLE BATTERIES:

Eveready ECR-2032-BP
Duracell DL-2032
Panasonic R-2032
Neda 5004-LC
Or equivalent CR2032 Type Battery





Diagnostic Procedure # 2

SYMPTOM:
Doors do not lock with remote control





Diagnostic Procedure # 3

SYMPTOM:
Doors do not unlock with remote control





Diagnostic Procedure # 4

SYMPTOM:
System will not passive arm when driver's door lock switch is pressed.





Diagnostic Procedure # 5

SYMPTOM:
Clearance lights do not flash





Diagnostic Procedure # 6

SYMPTOM:
No sound from siren





Diagnostic Procedure # 7

SYMPTOM:
Console switch LED will not flash





Diagnostic Procedure # 8

SYMPTOM:
Interior light does not operate (with unlock or alarm).





DIAGNOSTIC PROCEDURE # 9

SYMPTOM:
Zone continuity





Diagnostic Procedure # 10

SYMPTOM:
Alarm will not silence with key.





Diagnostic Procedure # 11

SYMPTOM:
No alarm with impact.





Diagnostic Procedure # 12

SYMPTOM:
Engine will not crank

Set parking brake, (A/T) place transmission in drive or neutral, (M/T) do not depress clutch.





Diagnostic Procedure # 13

Main Power Supply and Ground Circuit Checks.
VSS Control Unit Main Power Supply





IMPACT SENSOR INSPECTION, SIREN INSPECTION, CONSOLE SWITCH INSPECTION











VSS Control Unit Pin Test





Preparation For System Checks

Place console switch in the auto position move the interior lamp switch to the center position and open driver's side window. Close trunk hood (if open) and remove ignition key and close all doors.