Programming and Relearning

SETTING THE THEFT WARNING SYSTEM

Initial condition
1. Close all doors.
2. Close hood and trunk lid.

Disarmed phase
When the theft warning system is in the disarmed phase, the security indicator lamp blinks every 2.6 seconds.

Pre-armed phase and armed phase
The theft warning system turns into the "pre-armed" phase when hood, trunk lid and all doors are closed and locked by key or multi-remote controller. (The security indicator lamp illuminates.)
After about 30 seconds, the system automatically shifts into the "armed" phase (the system is set). (The security indicator lamp blinks every 2.6 seconds.)

CANCELING THE SET THEFT WARNING SYSTEM
When the following (a) or (b) operation is performed, the armed phase is canceled.
a. Unlock the doors with the key or multi-remote controller.
b. Open the trunk lid with the key or multi-remote controller.

ACTIVATING THE ALARM OPERATION OF THE THEFT WARNING SYSTEM
Make sure the system is in the armed phase. (The security indicator lamp blinks every 2.6 seconds.)
When the following operation (a) or (b) is performed, the system sounds the horns and flashes the headlamps for about 2.5 minutes.
a. Engine hood, trunk lid or any door is opened before unlocking door with key or multi-remote controller.
b. Driver's door is unlocked without using key or multi-remote controller.


INITIAL CONDITION TO ACTIVATE THE SYSTEM
The operation of the theft warning system is controlled by the doors, hood and trunk lid.
To activate the theft warning system, the smart entrance control unit must receive signals indicating the doors, hood and trunk lid are closed and the driver's door is locked.
When a door is open, smart entrance control unit terminals (15) or (16) receives a ground signal from each door switch.
When a door is unlocked, smart entrance control unit terminal (14) receives a ground signal:
- from terminal (4) of front door door unlock sensor LH
- through terminal (2) of front door door unlock sensor LH
- through body grounds (M2) and (M61) for the front door unlock sensor LH.
When the hood is open, smart entrance control unit terminal (29) receives a ground signal:
- from terminal (1) of the hood switch
- through terminal (2) of the hood switch
- through body grounds (E34) and (E10).
When the trunk lid is open, smart entrance control unit terminal (26) receives a ground signal:
- from terminal (1) of the trunk room lamp switch
- through terminal (2) of the trunk room lamp switch
- through body grounds (T6) and (T9),
when the theft warning system is in disarmed phase, if one of the described conditions exist, the theft warning indicator will blink every 2.6 seconds.

THEFT WARNING SYSTEM ACTIVATION (With key or remote controller used to lock doors)
If the key is used to lock doors, smart entrance control unit terminal (30) receives a ground signal:
- from terminal (1) of the front door key cylinder switch LH
- from terminal (3) of the front door key cylinder switch RH
- through terminal (2) of the front door key cylinder switch LH or RH
- through body grounds (M2) and (M61).
If this signal or lock signal from remote controller is received by the smart entrance control unit, the theft warning system will activate automatically.
Once the theft warning system has been activated, smart entrance control unit terminal (33) supplies ground to terminal (2) of the security indicator lamp.
The security lamp will illuminate for approximately 30 seconds and then blink every 2.6 seconds. Now the theft warning system is in armed phase.


THEFT WARNING SYSTEM DEACTIVATION
To deactivate the theft warning system, a door or the trunk lid must be unlocked with the key or remote
controller.
When the key is used to unlock a door, smart entrance control unit terminal (31) receives a ground signal:
- from terminal (3) of the front door key cylinder switch LH
- from terminal (1) of the front door key cylinder switch RH
- through terminal (2) of the front door key cylinder switch LH or RH
- through body grounds (M2) and (M61).
When the key is used to unlock the trunk lid, smart entrance control unit terminal (27) receives a ground signal:
- from terminal (1) of the trunk lid key cylinder switch
- through terminal (2) of the trunk lid key cylinder switch
- through body grounds (T6) and (T9).
When the smart entrance control unit receives either one of these signals or unlock signal from remote controller, the theft warning system is deactivated. (Disarmed phase)