Rear View Mirror

REMOVAL



Remove rearview mirror by pushing deflect spring with screwdriver as shown in the figure.

INSTALLATION




1. Install mounting bracket as follows:
a. Determine mounting bracket position on windshield by measuring from top of windshield to top of mounting bracket as shown in the figure.
b. Mark location on outside of windshield with wax pencil or equivalent.
c. Clean attaching point on inside of windshield with an alcohol-saturated paper towel.
d. Sand bonding surface of mounting bracket with sandpaper (No.320 or No.360).
e. Clean bonding surface of mounting bracket with an alcohol- saturated paper towel.
f. Apply Loctite Adhesive 11067-2 or equivalent to bonding surface of mounting bracket.
g. Install mounting bracket at premarked position and press mounting bracket against glass for 30 to 60 seconds.
h. After five minutes, wipe off excess adhesive with an alcohol- moistened paper towel.

2. Install rearview mirror.
- All dimensions indicated in figures are actual ones.
- When using a tracking gauge, adjust both pointers to equal length. Make sure there is no free play.
- When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
- Measurements should be taken at the center of the mounting holes.
- All measurements and mounting hole diameters are expressed in millimeters (mm).
- An asterisk (*) following the value at the measuring point indicates that the measuring point on the other side is symmetrically the same value.




- The coordinates of the measurement points are the distances measured from the standard line of "X", "Y" and "Z".