Gap and Height Adjustment

If any gap or height difference between lid and roof is found, check lid fit and adjust as follows:

Gap adjustment
1. Remove shade assembly. (Refer to removal procedures, for details.)
2. Tilt lid up.
3. Loosen lid securing bolts (2 each on left and right sides), then tilt lid down.
4. Adjust lid so it resembles "A - A" as shown in the figure.
5. Tilt lid up and down until it is adjusted to "B - B" as shown in the figure.
6. After adjusting lid, tilt lid up and tighten bolts.
7. Tilt lid up and down several times to check that it moves smoothly.

Height difference adjustment
1. Tilt lid up and down.
2. Check height difference between roof panel and lid to see if it is as "A - A" as shown in the figure. Adjust if necessary.