Front Seat

- When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage.
* For Wiring Diagram, refer to "POWER SEAT" for details.

CAUTION:
- Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
- Do not drop, tilt, or bump the side air bag module installed in the seat. Always handle it with care.

POWER SEAT:

MANUAL SEAT:

HEATED SEAT
- When handling seat, be extremely careful not to scratch heating unit.
- To replace heating unit, seat trim and pad should be separated.
- Do not use any organic solvent, such as thinner, benzene, alcohol, gasoline, etc. to clean trims.
* For Wiring Diagram, refer to "HEATED SEAT" for details.