Self Diagnosis With Consult-II or GST

SELF DIAGNOSIS WITH CONSULT-II or GST (Generic Scan Tool)
Examples: P0705, P0710, P0720, P0725, etc. These DTCs are prescribed by SAE J2012. (CONSULT also displays the malfunctioning component or system.)
- 1st trip DTC No. is the same as DTC No.
- Output of the diagnostic trouble code indicates that the indicated circuit has a malfunction. However, in case of the Mode II and GST they do not indicate whether the malfunction is still occurring or occurred in the past and returned to normal.
CONSULT can identify them as shown below. Therefore, using CONSULT-II (if available) is recommended.





A sample of CONSULT display for DTC is shown. DTC or 1st trip DTC of a malfunction is displayed in SELF-DIAGNOSTIC RESULTS mode for "ENGINE" with CONSULT-II. Time data indicates how many times the vehicle was driven after the last detection of a DTC.





If the DTC is being detected currently, the time data will be "0".





If a 1st trip DTC is stored in the ECM, the time data will be "245".

SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II)





1. Turn on CONSULT-II and touch "ENGINE" for OBD-II detected items or touch "A/T" for TCM self-diagnosis. If A/T is not displayed, check TCM power supply and ground circuit.





2. Touch "SELF DIAGNOSIS".
Display shows malfunction experienced since the last erasing operation.
CONSULT-II performs "Real Time Diagnosis".
Also, any malfunction detected while in this mode will be displayed at real time.

SELF-DIAGNOSTIC RESULT TEST MODE





Part 1 of 3





Part 2 of 3





Part 3 of 3

DATA MONITOR MODE (A/T)





Part 1 of 3





Part 2 of 3





Part 3 of 3


DTC WORK SUPPORT MODE WITH CONSULT-II
CONSULT-II Setting Procedure
1. Turn ignition switch OFF.





2. Connect CONSULT-II to Data link connector, which is located in left side dash panel.
3. Turn ignition switch ON.





4. Touch "START".





5. Touch "A/T".





6. Touch "DTC WORK SUPPORT".





7. Touch select item menu (1ST, 2ND, etc.).





8. Touch "START".





9. Perform driving test according to "DTC CONFIRMATION PROCEDURE" in "TROUBLE DIAGNOSIS FOR DTC".





- When testing conditions are satisfied, CONSULT-II screen changes from "OUT OF CONDITION" to "TESTING".








10. Stop vehicle. If "NG" appears on the screen, malfunction may exist. Go to "DIAGNOSTIC PROCEDURE".





11. Perform test drive to check gear shift feeling in accordance with instructions displayed.





12. Touch "YES" or "NO".








13. CONSULT-II procedure ended.
If "NG" appears on the screen, a malfunction may exist. Go to "DIAGNOSTIC PROCEDURE".

DTC WORK SUPPORT MODE





Part 1 of 2





Part 2 of 2