Window Glass (Front Door) - Squeak/Squeal Noise

Classification:
BT01-033

Reference:
NTB01-054

Date:
August 28, 2001

2000-01 MAXIMA; FRONT GLASS RUN RUBBER SQUEAK/SQUEAL NOISE

APPLIED VEHICLE:
2000-01 Maxima (A33)

APPLIED VINs:
2000 MY vehicles:
All VINs

2001 MY vehicles:
Built before:
JN1CA31A41J113276
JN1CA31A5T317794
JN1CA31D91T631619
JN1CA31D411836295

APPLIED DATE:
All vehicles built before: May 23, 2001

SERVICE INFORMATION

If an applied vehicle exhibits a squeak/squeal noise when the front door window glass goes up or down, use the following Service Procedure to resolve the incident, if it should occur.

SERVICE PROCEDURE

The following procedure applies to both front doors.

1. Determine the source of the squeak/squeal noise as follows:

A. Lower the front window glass(es).

B. Spray the window glass run rubber with silicone lubricant P/N 999MP-A3010 (or equivalent).

C. Raise and lower the window glass(es) several times.

^ If the squeak/squeal noise is gone, proceed with step 2 below.

^ If the squeak/squeal noise still exists, check for other causes of the noise.

2. Install the new front window glass run rubber according to the "BT" section of the applicable Service Manual.

NOTE:
Remove any debris (i.e., run rubber material, dirt, etc.) from both sides of the window glass surface, near the edge of the glass.

3. Raise and lower the window glass(es) several times to confirm the incident is resolved.





PARTS INFORMATION





CLAIMS INFORMATION