Collision Diagnosis
FOR FRONTAL COLLISIONTo repair the SRS, perform the following steps.
When SRS (except the side air bag) is activated in a collision:
1. Replace the diagnosis sensor unit.
2. Remove the air bag modules (except the side air bag module) and front seat belt pre-tensioner assemblies.
3. Check the SRS components using the table shown below:
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).
4. Install new air bag modules (except the side air bag module) and front seat belt pre-tensioner assemblies.
5. Conduct self-diagnosis using CONSULT-II or "AIR BAG" and "SEAT BELT" warning lamp. Refer to "Self-diagnosis" for details.
SEE DIAGNOSTIC PROCEDURE 1 AND 2.
[1][2]Component Tests and General Diagnostics
Diagnostic Procedure 2
Ensure entire SRS operates properly.
Part 1 Of 2:
Part 2 Of 2:
When SRS is not activated in a collision:
1. Check the SRS components using the table shown:
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).
2. Conduct self-diagnosis using CONSULT-II or "AIR BAG" and "SEAT BELT" warning lamp. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly.
FOR SIDE COLLISION
To repair the SRS for a side collision, perform the following steps.
When the side air bag is activated in the side collision:
1. Replace the following components:
- All parts of seat back (including seat back frame) with side air bag module (on the side on which side air bag is activated)
- Diagnosis sensor unit
- Side air bag (satellite) sensor (on the side on which side air bag is activated)
2. Check the SRS components and the related parts using the table shown.
Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation).
3. Conduct self-diagnosis using CONSULT-II, and "AIR BAG" and "SEAT BELT" warning lamp. Refer to "Self-diagnosis" for details.
SEE DIAGNOSTIC PROCEDURE 1 AND 2.
[1][2]Component Tests and General Diagnostics
Diagnostic Procedure 2
Ensure entire SRS operates properly.
When SRS is not activated in the side collision:
1. Check the SRS components and the related parts using the table shown.
Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation).
2. Conduct self-diagnosis using CONSULT-II, and "AIR BAG" and "SEAT BELT' warning lamp. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly.