Air Bag Systems: Service Precautions

- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.

- Before servicing the SRS, turn ignition switch "OFF", disconnect both battery cables and wait at least 3 minutes.
For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

- Diagnosis sensor unit must always be installed with their arrow marks "<=" pointing towards the front of the vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.

- The spiral cable must be aligned with the neutral position since its rotations are limited. Do not attempt to turn steering wheel or column after removal of steering gear.

- Handle air bag module carefully. Always place driver and front passenger air bag modules with the pad side facing upward and front side air bag module (built-in type) standing with the stud bolt side facing down.

- Conduct self-diagnosis to check entire SRS for proper function after replacing any components.

- After air bag inflates, the front instrument panel assembly should be replaced if damaged.