Trim Panel: Service and Repair

Part 1 Of 2:

Part 2 Of 2:

CAUTION:
- Wrap the tip of flat-beaded screwdriver with a cloth when removing metal clips from garnishes.

1. Remove A/T finisher or M/T shift lever boot. Refer to "Removal and Installation".
2. Remove the console. Refer to "Removal and Installation".
3. Remove front and rear seats. Refer to "Removal and Installation"(front and Rear).
4. Remove kick plates.
5. Remove dash side lower garnish.[A]
6. Remove body side welts.
7. Remove front pillar garnish.[B]
8. Remove front seat belt floor anchor bolt. Refer to "REMOVAL AND INSTALLATION".
9. Remove rear seat belt floor anchor bolt. Refer to "REMOVAL AND INSTALLATION".
10. Remove center pillar lower garnish.
11. Remove adjuster cover and pillar anchor bolt. Refer to "REMOVAL AND INSTALLATION".
12. Remove center pillar upper garnish.[C]
13. Remove rear pillar garnish.[D]
14. Remove parcel shelf.
15. Remove center rear seat back finisher.
16. Remove side rear seat back finishers.[E]
17. Remove floor carpet.