Starting System: Testing and Inspection
Trouble Diagnoses with Battery/Starting/Charging System TesterNOTE: To ensure a complete and thorough diagnosis, the battery, starter and generator test segments must be done as a set from start to finish.
1. Turn off all loads on the vehicle electrical system.
2. Perform battery test with Battery/Starting/Charging system tester. Refer to "Trouble Diagnoses with Battery/Starting/Charging System Tester".
3. Press "ENTER" to begin the starting system test.
4. Start the engine.
5. Diagnosis result is displayed on the tester. Refer to "DIAGNOSTIC RESULT ITEM CHART".
NOTE:
- If the starter performs normally but the engine does not start, perform engine diagnosis.
- For intermittent "NO CRANK" or "NO STARTER OPERATION" incidents, go to "DIAGNOSTIC PROCEDURE 2".
Diagnostic Result Item Chart:
DIAGNOSTIC RESULT ITEM CHART
Work Flow:
WORK FLOW
DIAGNOSTIC PROCEDURE 1 ("B" terminal circuit check)
DIAGNOSTIC PROCEDURE 2 ("S" terminal circuit check)
MINIMUM SPECIFICATION OF CRANKING VOLTAGE REFERENCING COOLANT TEMPERATURE