Door Mirror

REMOVAL
* For Wiring Diagram, refer to ("POWER DOOR MIRROR").

- Mirror glass must be removed to access internal mirror components (i.e. motor).
1. Remove sash inner cover.
2. Remove nuts securing door mirror, disconnect door mirror harness, then remove door mirror assembly.
3. Use a heat lamp (at least 500 watts) to warm the frame edge of the door mirror glass to approximately 70 °C (159 °F) for three minutes.
4. Insert a stiff blade scraper between the mirror glass and frame. Pry the glass loose and remove any remaining adhesive (butyl tape) from the mounting surface.

INSTALLATION
1. Install butyl/adhesive tape (2 pieces) on the frame
2. Warm the mirror glass frame edge thoroughly with a heat lamp. Position mirror glass on frame, carefully press on the mirror glass to seat it in place.