Rear Seat

Rear Seat:

When removing or installing the seat trim, handle carefully to keep dirt out and avoid damage.

* For Wiring Diagram, refer to ("POWER SEAT").

CAUTION:
- Before removing the front seat, turn the ignition switch off, disconnect both battery cable and wait at least 3 minutes.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
- Do not drop, tilt, or bump the side air bag module installed in the seat. Always handle it with care.
- Disconnect the side air bag harness connector and the power seat switch harness connector from under the seat before removing the seat.
- Disconnect the side air bag module before removing the seat back.