Collision Diagnosis

FOR FRONTAL COLLISION
To repair the SRS for a frontal collision, perform the following steps.

When SRS (except the side air bag) is activated in a collision:
1. Replace the diagnosis sensor unit.
2. Remove the air bag modules (except the side air bag module).
3. Check the SRS components using the table shown below:
- Replace any SRS components showing visible signs of damage (dents, cracks, deformation).

4. Install new air bag modules (except the side air bag module).
5. Conduct self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly. [1][2]Component Tests and General Diagnostics

When SRS is not activated in a collision:
1. Check the SRS components using the table shown below:
- Replace any SRS components showing visible signs of damage (dents, cracks, deformation).
2. Conduct self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly. [1][2]Component Tests and General Diagnostics

Part 1:

Part 2:

SRS Inspection

FOR SIDE COLLISION
To repair the SRS for a side collision, perform the following steps.

When the side air bag is activated in the side collision:
1. Replace the following component:
- All parts of the front seat back (including front seat back frame) with side air bag module (on the side of the vehicle on which the side air bag is activated).
- Diagnosis sensor unit
- Satellite sensor (on the side on which side air bag is activated)
2. Check the SRS components and the related parts using the table shown below.
- Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation).
3. Conduct self-diagnosis using CONSULT-II, and "AIR BAG" warning lamp. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly. [1][2]Component Tests and General Diagnostics

When SRS is not activated in the side collision:
1. Check the SRS components and the related parts using the table shown below.
- Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation).
2. Conduct self-diagnosis using CONSULT-II, and "AIR BAG" warning lamp. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly. [1][2]Component Tests and General Diagnostics

Part 1:

Part 2:

SRS Inspection (For side collision)