Warning Lamps

FUEL WARNING LAMP SENSOR CHECK
- It will take a short time for the bulb to light.




OIL PRESSURE SWITCH CHECK
Check the continuity between the terminals of oil pressure switch and body ground.




DIODE CHECK
- Check continuity using an ohmmeter.
- Diode is functioning properly if test results are as shown in the figure.
- Check diodes at the combination meter harness connector instead of on the combination meter assembly. Refer to Warning Lamps wiring diagrams.

NOTE: Specification may vary depending on the type of tester. Before performing this inspection, be sure to refer the tester to be used.