Rear Door: Service and Repair

Rear Door Glass
- Make sure that door glass is positioned in glass run groove.
- Make sure that there is no abnormality when door glass is raised or lowered.




REAR DOOR GLASS AND REGULATOR
- For removal of rear door trim, refer to "DOOR TRIM".
- For removal of door outside molding, refer to "EXTERIOR".
- Remove sealing screen.




1. Using power window main switch, raise or lower door glass until carrier plate securing bolts are visible.
2. Remove bolts securing carrier plate.




3. Remove partition sash at glass run.
4. Remove bolts and screw securing partition sash.




5. Hold door glass with both hands. While raising rear end of door glass, remove door glass from sash and away from inside the door.




6. Disconnect regulator assembly connector.
7. Remove bolts securing regulator assembly and guide rail, then remove regulator assembly and guide rail.




8. Remove partition glass.