Adjustment (2)

Adjustment (2)




When any parts listed are replaced, adjust total end play and reverse clutch end play.

TOTAL END PLAY





- Measure clearance between reverse clutch drum and needle bearing for oil pump cover.
- Select proper thickness of bearing race so that end play is within specifications.





1. Measure dimensions "K" and "L" and then calculate dimension "J".





a. Measure dimension "K".





b. Measure dimension "L".
c. Calculate dimension "J".
"J": Distance between oil pump fitting surface of transmission case and needle bearing mating surface of high clutch drum
J = K - L





2. Measure dimension "M".
a. Place bearing race and needle bearing on oil pump assembly.





b. Measure dimension "M".
"M": Distance between transmission case fitting surface and needle bearing on oil pump cover
"M1": Indication of gauge





c. Measure thickness of straightedge "t".
M = M1 - t

3. Adjust total end play "T3".
T3 = J - M
Total end play "T3": 0.25 - 0.55 mm (0.0098 - 0.0217 inch)
- Select proper thickness of bearing race so that total end play is within specifications.
Bearing races: Refer to "Total End Play", under Specifications; Mechanical.

REVERSE CLUTCH END PLAY





- Measure clearance between oil pump cover and thrust washer for reverse clutch drum.
- Select proper thickness of thrust washer so that end play is within specifications.





1. Measure dimensions "0" and "P" and then calculate dimension "N".
a. Place thrust washer on reverse clutch drum.





b. Measure dimension "0".





c. Measure dimension "P".
d. Calculate dimension "N".
"N": Distance between oil pump fitting surface of transmission case and thrust washer on reverse clutch drum
N = 0 - P





2. Measure dimensions "R" and "S" and then calculate dimension "Q".





a. Measure dimension "R".





b. Measure dimension "S".
c. Calculate dimension "Q".
"Q": Distance between transmission case fitting surface and thrust washer mating surface
Q = R - S
3. Adjust reverse clutch end play "T4".
T4 = N - 0
Reverse clutch end play: 0.65 - 1.00 mm (0.0256 - 0.0394 inch)
- Select proper thickness of thrust washer so that reverse clutch end play is within specifications. Thrust washer: Refer to "Reverse Clutch End Play", under Specifications; Mechanical.