P0105

Component Description
The absolute pressure sensor is built into ECM. The sensor detects ambient barometric pressure and sends the voltage signal to the micro computer. As the pressure increases, the voltage rises.

On Board Diagnosis Logic:

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

With CONSULT-II
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.




3. Wait at least 10 seconds.
4. If 1st trip DTC is detected, go to "Diagnostic Procedure" below.

With GST
Follow the procedure "With CONSULT-II" above.


Diagnostic Procedure

Diagnostic Procedure Steps 1 - 2: