P0600

System Description
These circuit lines are used to control the smooth shifting up and down of A/T during the hard acceleration/deceleration. Voltage signals are exchanged between ECM and TCM (Transmission control module).

On Board Diagnosis Logic:

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10.5 V at ignition switch "ON".

With CONSULT-II
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.




3. Wait at least 10 seconds.
4. If DTC is detected, go to "Diagnostic Procedure" below.

EC-AT/C-01:

EC-AT/C-01 Connector View:

ECM Terminals And Reference Value:

Wiring Diagram

Diagnostic Procedure

Diagnostic Procedure Steps 1 - 3: