P0705

Description





- The PNP switch assembly includes a transmission range switch.
- The transmission range switch detects the selector lever position and sends a signal to the TCM.





ON BOARD DIAGNOSIS LOGIC

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II
1) Turn ignition switch "ON".





1 of 2





2 of 2

2) Select "DATA MONITOR" mode for "ENGINE" with CONSULT II.
3) Start engine and maintain the following conditions for at least 5 consecutive seconds.
VHCL SPEED SE: 10 km/h (6 MPH) or more
THRTL POS SEN: More than 1.3 V
Selector lever: D position (OD "ON" or "OFF")

With GST
Follow the procedure "With CONSULT-II".





Wiring Diagram - AT - PNP/SW





TRANSMISSION CONTROL MODULE TERMINALS AND REFERENCE VALUE

Diagnostic Procedure

Diagnostic Procedure Step 1:

1 CHECK PNP SWITCH CIRCUIT (With CONSULT-II)

Diagnostic Procedure Step 2:

2 CHECK PNP SWITCH CIRCUIT (Without CONSULT-II)

Diagnostic Procedure Step 3:

3 CHECK DTC

Component Inspection
PARK/NEUTRAL POSITION SWITCH





Location: Terminals





Table





Location: PNP

1. Check continuity between terminals 1 and 3 and between terminals 2 and 4, 5, 6, 7, 8, 9 while moving manual shaft through each position.
2. If NG, check again with control cable disconnected from manual shaft of A/T assembly. Refer to step 1.
3. If OK on step 2, adjust control cable.
4. If NG on step 2, remove PNP switch from A/T and check continuity of PNP switch terminals. Refer to step 1.
5. If OK on step 4, adjust PNP switch.
6. If NG on step 4, replace PNP switch.