P1760

Description





The overrun clutch solenoid valve is activated by the TCM in response to signals sent from the inhibitor switch, overdrive control switch, vehicle speed and throttle position sensors. The overrun clutch operation will then be controlled.





ON BOARD DIAGNOSIS LOGIC

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test. TESTING CONDITION: Always drive vehicle on a level road to improve accuracy of test. After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II





1 of 2





2 of 2

1) Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
2) Start engine.
3) Accelerate vehicle to a speed of more than 10 km/h (6 MPH) with "D" position (OD "ON").
4) Release accelerator pedal completely with "D" position (OD "OFF").

With GST
Follow the procedure "With CONSULT-II".





Wiring Diagram-AT-OVRCSV





TRANSMISSION CONTROL MODULE TERMINALS AND REFERENCE VALUE BETWEEN TERMINAL AND GROUND

Diagnostic Procedure

Diagnostic Procedure Step 1:

1 CHECK VALVE RESISTANCE

Diagnostic Procedure Step 2:

2 CHECK POWER SOURCE CIRCUIT

Diagnostic Procedure Step 3:

3 CHECK DTC

Component inspection
OVERRUN CLUTCH SOLENOID VALVE





Resistance Check





- Check resistance between two terminals.

Operation Check





- Check solenoid valve by listening for its operating sound while applying battery voltage to the terminal and ground.