CONSULT-II / Inspection Procedure

1. With the ignition switch OFF, connect CONSULT-II to the data link connector, and turn the ignition switch ON.




2. Touch "START".




3. Select the desired part to be diagnosed on the "DIAGNOSIS SYSTEM SELECTION" screen.




4. Touch "SELF-DIAG RESULTS".
- The screen shows the detected malfunction and how many times the ignition switch has been turned since the malfunction.

5. Make the necessary repairs following the diagnostic procedures.
6. After the malfunctions are repaired, erase the self-diagnostic results stored in the control unit by touching "ERASE".

NOTE: "SELF-DIAG RESULTS" screen shows the detected malfunction and how many times the ignition switch has been turned since the malfunction.