Diagnostic Procedure 5

DIAGNOSTIC PROCEDURE 5

Inspecting SRS intermittent malfunction by using CONSULT-II Diagnosis - mode




1. Turn ignition switch OFF.
2. Connect "CONSULT-II" to data link connector.




3. Turn ignition switch ON.
4. Touch "START".




5. Touch "AIR BAG".




6. Touch "SELF-DIAG [PAST]".




7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.




If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".




8. Touch "TROUBLE DIAG RECORD".

NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.




9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to "CONSULT-II Diagnostic Code Chart ("SELF-DIAG [PAST] or TROUBLE DIAG RECORD)".
12. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears.
13. Turn ignition switch OFF, then turn off and disconnect CONSULT-II, and both battery cables.
14. Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart" that corresponds to the self-diagnostic result. For replacement procedure of component parts, refer to the Removal and Installation procedure for the appropriate component.
15. Go to "DIAGNOSTIC PROCEDURE 3" ,for final checking.