Supplemental Restraint System (SRS) Service

PRECAUTIONS FOR SRS "AIR BAG" AND "SEAT BELT PRE-TENSIONER" SERVICE
Do not use electrical test equipment to check SRS circuits unless instructed to do so.


Before Servicing the SRS
Before servicing the SRS, turn ignition switch "OFF", disconnect battery ground cable and wait at least 3 minutes.

For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy.

Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

Component Service and Repair
* Diagnosis sensor unit must always be installed with their arrow marks "<-" pointing towards the front of the vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.

* The spiral cable must be aligned with the neutral position since its rotations are limited. Do not attempt to turn steering wheel or column after removal of steering gear.

* Handle air bag module carefully. Always place driver and passenger air bag modules with the pad side facing upward and side air bag module standing with the stud bolt side setting bottom.

* Conduct self-diagnosis to check entire SRS for proper function after replacing any components.

* After air bag inflates, the front instrument panel assembly should be replaced if damaged.