Impact Sensor: Service and Repair

SIDE AIR BAG (SATELLITE) SENSOR

Removal and Installation

REMOVAL

CAUTION:
- Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
- Do not use old nut or bolt coated with bonding agent after removal; replace with new ones.
- Check side air bag (satellite) sensor to ensure they are free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with new one.
- Do not attempt to disassemble side air bag (satellite) sensor.
- Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.




1. Remove front seat belt pre-tensioner. Refer to "Removal and Installation".
2. Disconnect side air bag (satellite) sensor connector.
3. Remove bolt and nuts from side air bag (satellite) sensor unit. Then remove the side air bag (satellite) sensor.

INSTALLATION

CAUTION:
- Check side air bag (satellite) sensor for proper installation.
- After replacement of side air bag (satellite) sensor, check SRS function and perform self-diagnosis. Refer to "SRS Operation Check" for details.

To install, reverse the removal procedure sequence.