Symptom Related Diagnostic Procedures

Diagnostic Procedure
SYMPTOM 1:
- Selector lever cannot be moved from "P" position with key in ON position and brake pedal applied
- Selector lever can be moved from "P" position with key in ON position and brake pedal release
- Selector lever can be moved from "P" position when key is removed from key cylinder.

SYMPTOM 2: Ignition key cannot be removed when selector lever is set to "P" position. It can be removed when selector lever is set to any position except "P".

1. CHECK KEY INTERLOCK CABLE
Check key interlock cable for damage.
OK or NG
OK >>GO TO 2.
NG >> Repair key interlock cable

2. CHECK SELECTOR LEVER POSITION
Check selector lever position for damage.
OK or NG
OK >> GO TO 3.
NG >> Check selector lever.

3. CHECK POWER SOURCE





1. Turn ignition switch to "ON" position. (Do not start engine.)
2. Check voltage between stop lamp switch harness connector - M26 terminal + (R/Y) and ground.
Voltage: Battery voltage
OK or NG
OK >>GO TO 4.
NG >> Check the following items:
1. Harness for short or open between battery and stop lamp switch harness terminal +
2. 1 OA fuse No. 2 [located in the fuse block (J/B)]
3. Ignition switch.

4. CHECK INPUT SIGNAL (A/T DEVICE)





Turn ignition switch to "ON" position.
(Do not start engine.)
- Check voltage between A/T device harness terminal 7 and ground.
OK or NG
OK >> GO TO 5.
NG >> Check the following items:
1. Harness for short and open between battery and stop lamp switch harness connector 1
2. Harness for short or open between stop lamp switch harness connector 2 and A/T device harness connector 7
3. Fuse
4. Stop lamp switch.

5. CHECK GROUND CIRCUIT
1. Turn ignition switch to "OFF" position.
2. Disconnect A/T device harness connector.





3. Check continuity between A/T device harness terminal 6 and ground. If OK, check harness for short to ground and short to power.
OK or NG
OK >> GO TO 6.
NG >> Repair open circuit or short to ground or short to power in harness or connectors.

6. CHECK RELAY CIRCUIT





1. Turn ignition switch to ON.
- Check voltage between terminal 7 - 6 and 5 - 6.
OK or NG
OK >> GO TO 7.
NG >> Replace A/T device.

7. CHECK PARK POSITION SWITCH
Refer to "A/T DEVICE CHECK". OK or NG
OK >> GO TO 8.
NG >> Replace A/T device.

8. CHECK SHIFT LOCK SOLENOID
Refer to "A/T DEVICE CHECK". OK or NG
OK >> GO TO 9.
NG >> Replace A/T device.

9. SHIFT LOCK OPERATION
1. Reconnect shift lock harness connector.
2. Turn ignition switch from "OFF" to "ON" position. (Do not start engine.)
3. Recheck shift lock operation.
OK or NG
OK >> INSPECTION END.
NG >>
1. Perform A/T device input/output signal inspection test.
2. If NG, recheck harness connector connection.